GALAX RANGE
GALAX H40 & RH40
Available in three different versions:
* Built-in double hydraulic pump unit. (PTO speed : 540 rpm)
* Cutting angle holding device : hydraulic parallelogram
* Orientation crown on the chassis for 180° rotation of all arms --> Only for GALAX RH40
- Equipped with 4 or 5 knife plates with 360° movable knives
- Gear motor 8 cm3 in 3
- Transmission power 14 HP
- Rotation speed: 3400 rpm
- Cutting length: 1.50 m or 1.83 m
- Cutting capacity: 25 mm
Prices starting from £32,224 + VAT
Free Delivery (Mainland UK)!
GALAX H50 & RH50
* Complete chassis adaptable to rear or front lift arms
* Built-in double hydraulic pump unit. Equipped with roto-moulded tanks (PTO speed: 540 rpm)
* Orientation crown on the chassis for 180° rotation of all arms --> Only for GALAX RH50
- Equipped with 4 or 5 knife plates with 360° movable knives
- Gear motor 8 cm3 in 3
- Transmission power 14 HP
- Rotation speed: 3400 rpm
- Cutting length: 1.50 m or 1.83 m
- Cutting capacity: 25 mm
Prices starting from £36,272 + VAT
Free Delivery (Mainland UK)!
GALAX 4100
* Complete chassis adaptable to rear lift arm, (Size at rear right side) * Cutting angle holding device: Double parallelogram
* Built-in dual hydraulic pump unit (PTO speed 540Tr/min)
* Proportional valves with electric controls
- Equipped with 4 or 5 knife plates with 360° movable knives
- Gear motor 8 cm3 in 3
- Transmission power 14 HP
- Rotation speed : 3400 rpm
- Cutting length: 1.50 m or 1.83 m
- Cutting capacity: 25 mm
Prices starting from £25,041 + VAT
Free Delivery (Mainland UK)!
GALAX 2500
* Complete chassis predisposed for 3-point rear hitch on Category I (size at the rear right side)
* Removable dual hydraulic power unit (PTO speed 540Tr/min) : 40 l hydraulic tank with filtration, venting, level gauge, drain plug
* Electrohydraulic movement control valve with flow regulator to regulate the speed of the movements
* Electrohydraulic distributor for starting the Lamier in two directions
Prices starting from £13,680 + VAT
Free Delivery (Mainland UK)!
GALAX 3200
* Complete chassis adaptable on front or rear lift arms * Hydraulic tank integrated to the chassis capacity 40 L * Aero-cooler
* Double pump with multiplier: PTO speed 540 rpm
* Set of 2 arms actuated by double-acting cylinders with safety valve on valve block
* Release system on 2nd arm by spring for use of the rotor and locking system for use of the Lamier * Cutting equipment support piece with 4-hole hitching bracket and orientation notched nut
* Electro-hydraulic distributor fixed on the chassis
* Hydraulic coupler kit for connecting the tool at the end of the arm
* Control panel to be positioned at the driver's station including:
- Start-up of the cutting equipment
- Monolever all or nothing for the control of the movements - Protective fuse and emergency stop